Olympic Kilns introduces the Crucible 18 for hot glass. The Crucible 18 is built with heavy insulation consisting of 3” thick brick walls and 1” fiber blanket surrounded by a solid stainless steel jacket. A 1” ceramic fiberboard gasket retains the heat in the kiln when gathering glass from the crucible. When ordering, customized gasket openings can be cut to the size of the crucible which will be used.
The 3” thick separate kiln bottom may be turned over or easily replaced if damaged. The kiln is built with a counter weighted lid cover making gathering glass safe and easy.
The counter weighted cover lifts to reveal the opening in the lid. A stainless steel trough on the lid directs glass back into the crucible minimizing lid damage.
Four (4) sets of elements can be used for rapid heat up. Two (2) sets are required to maintain temperature, two (2) sets in reserve to prevent unwanted cooling if an element is lost while firing. The Crucible 18 is equipped with an automatic lid shut-off which shuts the elements off when the lid of the kiln is opened, a Bartlett 3 Key electronic controller with four ramp/hold programs, and a Type K or Type S thermocouple may be chosen when ordering .
The Crucible 18’s inside dimensions are 17.5” wide x 18” deep, 2.63 cu. ft. and the outside dimensions are 31” wide x 39” deep x 35.5” high (kiln), 51.5” high (counter weight) with a shipping weight of 270 lbs. The kiln runs on 48 amps, 240 volt, 11,500 watts, and NEMA 6-50 power cord. A NEMA 6-50 receptacle and 60-amp breaker are required. Copper wire size is #6 or #4 if circuit longer than 40 ft. Maximum temperature – 2350°F.
Crucible 18 $2,165.00
Crucible 18 with Type S Thermocouple $2,490.00
To order contact Olympic Kilns for a distributor near you
Phone 800.241.4400 ♦ 770.967.4009 ♦ Fax 770.967.1196
|
